Supplies
Step 1
Stick the flat head Screw Driver in between the light housing and black cover, pull towards you and the whole thing will pop out.
Step 2
Find the 2 bolts securing the Fog light assembly, use a 10mm nut driver to unscrew them both.
Step 3
Remove the entire housing, pull the bolted side all the way towards you then slide the housing towards your license plate to remove. Then remove the connector in the rear by pushing in the 2 side clips.
Step 4
Pull the metal clip away from the housing, then pull up on the same side to release the top cover.
Step 5
Pull off the 2 Blue connectors carefully. then undo the 2 clips holding in the bulb by pushing them down and in to allow them to spring up.
Step 6
Remove the bulb and put in the new one, apply Di-Electric grease on the prongs of the bulb and reinstall the blue connectors. Make sure the tab that sticks out on the bulb is in between the 2 pegs on the housing. [As Pictured Above]
Reinstall the housing lid and always test the lights before putting everything together.
Reinstall the housing lid and always test the lights before putting everything together.