Supplies
O2 Sensor [11781247406]
O2 Sensor Socket
Breaker Bar
Torque Wrench
Anti Seize
Rhino Ramps and Tire Chocks
New Zip tie
O2 Sensor Socket
Breaker Bar
Torque Wrench
Anti Seize
Rhino Ramps and Tire Chocks
New Zip tie
Step 1
Drive the car onto Rhino Ramps and secure the rear wheels with tire chocks. Locate the O2 Sensor, go under the car from the front and look on the Passengers side for the Exhaust Pipe. You will see the Sensor sticking out of the side of the pipe.
Step 2
Follow the Wire coming out of the Sensor until you get to the Black Connector. Unplug it by pulling apart, then cut the Zip Tie holding the wire to the chassis.
Step 3
Use a Breaker Bar and an O2 Sensor socket to Remove the old sensor. [This may not be an easy task, You're going to have to use some muscle. Warm the exhaust up by letting the car run to loosen the sensor.]
Step 4
Take the new Sensor and apply Anti Seize to it. [Don't get anti seize on or touch the tip of the sensor!]
Step 5
Install the sensor carefully! Screw it in hand tight and then torque it to 40 Ft-Lbs. Reconnect the Sensor and then re-Zip tie the wire to the chassis.