Supplies
This can be done with a number of different parts, but I will list what I used.
3 inch Intake Tube
2x 3 inch Hose clamps
3 inch Intake Mount
Silicone RTV Sealant
Drill and drill bit or hole saw 3 inch
File
Something sharp or wire cutters
10mm Socket and Wrench
3 inch Intake Tube
2x 3 inch Hose clamps
3 inch Intake Mount
Silicone RTV Sealant
Drill and drill bit or hole saw 3 inch
File
Something sharp or wire cutters
10mm Socket and Wrench
Part 1
Remove the 4 10mm bolts holding down the plastic cover, then remove the cover.
Part 2
Disconnect temp sensor connector and remove airbox.
Part 3
Trace a hole as far to the right corner as you can and then either drill holes in it and then file the edges or use a hole saw to make a hole.
Part 4
You may need to make some modifications to the hose mount so that it will fit. Apply silicone to the edge before pulling it through the box.
Part 5
Put on the coupler and a clamp, reinstall the box and route the hose to the scoop that goes to the kidney grill.